This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
This 20W Constant Current Dimmable Driver is compatible with our Clara, Sofia, MAYA, MIA, Chloe & Ella marker lights range. This driver is IP20 design for indoor installations, constant current mode output with current (mA) multiple levels selectable by dip switch. Short Circuit/ Over Load/ Over Current Protections, Full Protection plastic housing easy installation. Cooling by free air convection. Input Voltage: 180-240VAC, Output Voltage: 3-22VDC , Output Range: 150mA-700mA. . Dimming Function: Triac Dimmable.
Dimension: 140 x 45 x 27mm
We recommend circuit load of this driver to be a minimum of 20% and no higher than 80% for good dimming result.
To install this driver, you will need to cut off the Non dimmable driver supplied with the fitting and wire the fitting in SERIES (NOT PARALLEL) to this driver, this installation should only be carried out by a qualified professional.
This dimmable driver is used for multiple fittings, there are a range of current settings on our dimmable driver. You will need to set the correct current (via the dip switches on the dimmable driver) for your fitting.
Please do not turn on the POWER without selecting the correct current output via the dip switches. Due to it will result in the fittings failing prematurely/ fittings blowing.
Failure to wire the fittings correctly & selecting an correct current output (ma) will void the warranty.
See below diagrams of Series & Parallel wiring
See below a diagram of the current mode range:
See below which current settings need to be selected per fitting:
- Ella Marker Light – 250ma
- Clara Marker Light – 250ma
- Maya Marker Light – 250ma
- Chloe Marker Light – 600ma
- MIA Low Level – 600ma
- Sofia Low Level – 600ma