20W IP20 Marker Light Dimmable Driver Series Wired for Clara, Sofia, MAYA, MIA, Chloe & Ella

20W Constant Current Dimmable Driver (Triac Dimming)

This 20W dimmable driver is designed for indoor use (IP20) and works with our Clara, Sofia, Maya, Mia, Chloe, and Ella marker lights.

Specifications:

• Input: 180-240V AC
• Output: 3-22V DC, 150-700mA (set by DIP switch)
• Dimming: Triac (phase cut)
• Size: 140x 45x 27 mm
• Protection: Short circuit, overload, overcurrent

Installation Notes:

• Replace the supplied non-dimmable driver.
• Wire fittings in series (not parallel).
• Set the correct current via DIP switch before powering on.
• Incorrect wiring or current setting will cause failure and void the warranty.
• Installation must be done by a qualified professional
• Dimming performance may vary depending on the dimmer used. Incorrect wiring or current selection may damage the LED fitting and void the warranty.

Recommendation:
For best dimming, load should be 20-80% of the driver's capacity.

See below diagrams of Series & Parallel wiring

See below a diagram of the current mode range:

Current Settings per Fitting (via DIP switch):

• Ella Marker Light - 250mA

• Clara Marker Light - 250mA

• Maya Marker Light - 250mA

• Chloe Marker Light - 600mA

• Mia Low Level - 600mA

• Sofia Low Level - 600mA